• How do I replace my oxygen sensor?
  • REPLACING OXYGEN SENSORS
  • REPLACING OXYGEN SENSORS
  • How Much Does It Cost to Replace an Oxygen Sensor? The Location of the Oxygen Sensors on a Chrysler Sebring Convertible Bank...

3/8-Inch Drive by 7/8-Inch (22mm) Offset Oxygen Sensor Socket |ARES 70039| Wire Gate Accesses Sensor from the Side, Preventing Damage to Wires

Too low to display

There is no coding, re-mapping or updating required when you replace the oxygen sensors. If you have generated a fault code (check-engine light), the fault code will need to be cleared. This can be done with a standard fault code reader & reset tool. Note that the tool that we offer also resets the oil change and inspection reminders on all BMWs through 2000-2001, depending on the model. If the car has an underhood DLC (Data Link Connector) port, the tool will be used to reset the reminders. The DLC port is the round (about 2.5″) or smaller “D” shaped (most models through the mid-late ’80s) diagnostic port.

There is no coding, re-mapping or updating required when you replace the oxygen sensors. If you have generated a fault code (check-engine light), the fault code will need to be cleared. This can be done with a standard fault code reader & reset tool. Note that the tool that we offer also resets the oil change and inspection reminders on all BMWs through 2000-2001, depending on the model. If the car has an underhood DLC (Data Link Connector) port, the tool will be used to reset the reminders. The DLC port is the round (about 2.5″) or smaller “D” shaped (most models through the mid-late ’80s) diagnostic port.

Reviews

Bosch 4-Wire OE Replacement Oxygen Sensor - JCWhitney

There is no coding, re-mapping or updating required when you replace the oxygen sensors. If you have generated a fault code (check-engine light), the fault code will need to be cleared. This can be done with a standard fault code reader & reset tool. Note that the tool that we offer also resets the oil change and inspection reminders on all BMWs through 2000-2001, depending on the model. If the car has an underhood DLC (Data Link Connector) port, the tool will be used to reset the reminders. The DLC port is the round (about 2.5″) or smaller “D” shaped (most models through the mid-late ’80s) diagnostic port.